Thursday, December 26, 2013

Nokia Lumia 610 Mic Problem Solution By Jumpering


Lumia 610 mic problem solution by jumper trick.
Nokia lumia 610 mic not working solution by jumpering, nokia lumia 610 mic ways jumpers.
First try to change mic with new one.if problem not solved then try to trace missing mic points with
multi meter.The diagram below is solution for nokia lumia 610 mic problem.Check all points as shown
in diagram below and make jumpers like diagram.
mic problem nokia lumia 610
Read more »

Sunday, December 22, 2013

How To Hard Reset Qmobile Noir A50

This post is about Qmobile Nnoir A50 hard reset to solve pattern lock problem and slow performance of 
mobile.After this method your mobile will be at orignal factory settings.
Note:  Before do that take backup of your important data, phonebook, messages, images, and take out sim card and SD Card.Because after hard reset it is not possible to recover all data so it is important to take backup of all your data.


Make sure your mobile battery is charged 90% .
Turn off the mobile....
Press and hold Volume up+Volume down and power keys together.
After 6 to 7 seconds release power key only
The device will start up with  little Androidman logo with Exclamation mark.
Tap the HOME soft key at the bottom of the device (In between the MENU andthe RETURN soft keys).
Select with volume down key (Wipe data / factory reset) and power key to confirm.
Use the VOL DOWN key again to select YES - delete all user data and pressthe PWR key to CONFIRM
Once the Formatting is complete , press the PWR key to confirm a REBOOT
Read more »

Nokia C1-00 Dual Sim insert Sim Solution

Problem:
Nokia C1-00 insert Sim Problem
Nokia C1-00 Sim Not Accept Problem
Solution:
Here Diagram Shows Both Sim ics First Heat Sim Ics if Not Work Then Make Jumper
Like Diagram Below.

Read more »

Nokia lumia 800 No Network Low Signal Problem Solution

Problem:
Nokia Lumia 800 Low Signal Problem
Nokia Lumia 800 No Network Solution
Solution:
Nokia Lumia 800 No Network Low Signals Problems Solution is possible with a few steps that I am going to write in this post.In diagram bellow you can see red lines around Ic and a capacitor.

Clean these parts with electronics cleaner and apply hot air so that it can be dry. Re sold Ic and Check Vreg voltage on the capacitor.
Read more »